Paper
13 November 2019 The verification method of steel tape based on image processing
Author Affiliations +
Proceedings Volume 11343, Ninth International Symposium on Precision Mechanical Measurements; 1134310 (2019) https://doi.org/10.1117/12.2548584
Event: International Symposium on Precision Mechanical Measurements 2019, 2019, Chongqing, China
Abstract
Steel tape is a commonly used length-measuring tool, which needs to be verified before using. In this paper, a method based on image processing for steel tape verification, which replaces the traditional eye detection, is proposed. Firstly, the camera is calibrated to get the pixel equivalent. Secondly, the standard steel tape and steel tape to be measured are arranged side by side on the calibration table, and the image of the integral meter is collected by the CCD camera. Thirdly, the acquired image is divided into regions, then the fine regions are further divided, and the area where the integral meter scale line locates is selected by the frame. Finally, the coordinates of the scale line at the integral meter are extracted and calculated by the method of pixel traversal and gray center of gravity. The error of the steel tape can be obtained by multiplying the difference between them by the pixel equivalent. The verification process is efficient and the results are reliable. The resolution of the measurement system can reach 0.04 mm, which meets the requirements of the measurement task.
© (2019) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Rui Li, Jiaming Cao, Huakun Jia, Huining Zhao, and Liandong Yu "The verification method of steel tape based on image processing", Proc. SPIE 11343, Ninth International Symposium on Precision Mechanical Measurements, 1134310 (13 November 2019); https://doi.org/10.1117/12.2548584
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Image processing

Image filtering

Binary data

CCD cameras

Calibration

Image segmentation

Cameras

RELATED CONTENT

Profile detection system for transparent parts' shaping
Proceedings of SPIE (September 19 2013)
Small rotation angle measurement using an imaging method
Proceedings of SPIE (November 16 1999)
Multisensor system self-calibration
Proceedings of SPIE (September 13 1995)
Test-range calibration of digital camera's inner parameters
Proceedings of SPIE (December 31 2008)

Back to Top