Paper
15 January 1996 Basketweave test "apparent" microbending loss induced by differences in optical fiber coating bulk and surface cure
Peter R. Stupak, B. Bellerive
Author Affiliations +
Proceedings Volume 2611, Optical Network Engineering and Integrity; (1996) https://doi.org/10.1117/12.230106
Event: Photonics East '95, 1995, Philadelphia, PA, United States
Abstract
The 'apparent' microbend sensitivity of 62.5/125 micrometer graded index multimode fiber was examined as a function of both cure temperature and oxygen concentration present during cure for three UV curable acrylate coatings. The 'basketweave' test was used to quantify the microbending loss. Two coating materials cured under elevated temperature conditions exhibited increased microbending loss response at ambient test temperatures. One of the two coatings cured as a function of decreasing oxygen concentration exhibited increased loss at both ambient and low test temperatures. The microbending loss for both experiments was time dependent. Potential mechanisms responsible for the loss behavior observed in both experiments were proposed and supported with strip force and fiber friction force data.
© (1996) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Peter R. Stupak and B. Bellerive "Basketweave test "apparent" microbending loss induced by differences in optical fiber coating bulk and surface cure", Proc. SPIE 2611, Optical Network Engineering and Integrity, (15 January 1996); https://doi.org/10.1117/12.230106
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Coating

Fiber coatings

Oxygen

Signal attenuation

Temperature metrology

Optical fibers

Ultraviolet radiation

Back to Top