Paper
23 March 2001 Heat treatment of metals optimized by numerical simulation based on infrared thermographic measurement
Igor Sundov, Srecko Svaic
Author Affiliations +
Abstract
The analysis of complex probe geometry heating and cooling was done with the aim to find the temperature distribution inside the probe versus time. An infrared thermography was used to measure surface temperatures while temperatures in control points inside the probe were measured with thermocouples. The results obtained by numerical model based on the control volume approach, where thermographic measurements were the input parameters, show good mutual accordance with those measured by thermocouple at referent points of the probe. Applied on heat treatment of metals, this method provides a possibility to monitor temperature change for each single point inside the probe in a way which will guarantee that the desired microstructure is obtained. The local and average heat transfer coefficients have also been calculated by means of a numerical model. Based on the data, it is possible to simulate similar processes without providing measurements for all possible setups of the furnace parameters. Additional optimization is possible when experimental rig for real time calculation of temperature fields (measurement and calculation at the same time) will be realized.
© (2001) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Igor Sundov and Srecko Svaic "Heat treatment of metals optimized by numerical simulation based on infrared thermographic measurement", Proc. SPIE 4360, Thermosense XXIII, (23 March 2001); https://doi.org/10.1117/12.421048
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Temperature metrology

Heat treatments

Metals

Thermal modeling

Computer simulations

Infrared radiation

Control systems

Back to Top