Novel silicon bulk micromachining process for submillimeter rectangular waveguide fabrication

Ken K. Ma; Timothy D. Drysdale; Richard J. Blaikie; David R. S. Cumming

doi:10.1117/12.425324

30 April 2001 Novel silicon bulk micromachining process for submillimeter rectangular waveguide fabrication

Ken K. Ma, Timothy D. Drysdale, Richard J. Blaikie, David R. S. Cumming

Proceedings Volume 4407, MEMS Design, Fabrication, Characterization, and Packaging; (2001) https://doi.org/10.1117/12.425324
Event: Microelectronic and MEMS Technologies, 2001, Edinburgh, United Kingdom

Abstract

Micromachining of ultra-high frequency waveguide structures requires etching with vertical sidewalls and flat bottoms simultaneously. The required geometries can be difficult to achieve using a single-step orientation dependent etching (ODE) process without incurring a severe mask-undercutting penalty. This may inhibit the production of isolated convex structures, such as the central pillars that are required to couple radiation into the waveguide. In this paper we will described a new technique for ODE of deep, vertical sidewall structures in (100) Si with reduced undercut etching. The process uses a two stage KOH/IPA etch with a mask pattern that is designed to compensate for the differing etch rates on the Si planes. To date we have achieved overall etch depths of 350 microns, with a lateral undercut of as little as 275 microns, compared with a 350 micron undercut for a single-stage etch. The sidewalls are at exactly 90 degrees to the surface of the (100) Si, and the bottoms of the trenches are smooth and flat. Using the process we have also been able to routinely fabricate isolated, square pillars as small as 50 X 50 square microns, and over 300 microns high. The process enables structures to be made that might previously only have been possible with high-density-plasma dry etch techniques. The new technique has clear advantages of low cost and high throughput.

Citation Download Citation

Ken K. Ma, Timothy D. Drysdale, Richard J. Blaikie, and David R. S. Cumming "Novel silicon bulk micromachining process for submillimeter rectangular waveguide fabrication", Proc. SPIE 4407, MEMS Design, Fabrication, Characterization, and Packaging, (30 April 2001); https://doi.org/10.1117/12.425324

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available