Paper
13 May 2016 Applications of signal multiplexing in fiber optic-based acoustic and seismic sensors
R. Daniel Costley, William R. Folks, Clay K. Kirkendall, Gustavo Galan-Comas, Eric W. Smith, Michael W. Parker, Kent K. Hathaway
Author Affiliations +
Abstract
Fiber optic systems are deployed in a variety of settings as strain sensors to locate small disturbances along the length of the optical fiber cable, which is often tens of kilometers long. This technology has the advantages of low cost and design simplicity, as the sensor is its own source of telemetry and may be easily repaired or replaced. One of the limitations of current technology is noise from optical backscatter events in the fiber resulting in a degraded signal in individual spatial zones leading to signal fading. Detection within these zones along the length of the fiber is then obscured. Signal multiplexing may be used to increase sensitivity and signal-to-noise ratio and reduce signal fading. In such an architecture, multiple channels are multiplexed together and transmitted along the fiber. In this article, we report on results from two different systems that were tested using such techniques. Results are then compared with a single channel system.
© (2016) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
R. Daniel Costley, William R. Folks, Clay K. Kirkendall, Gustavo Galan-Comas, Eric W. Smith, Michael W. Parker, and Kent K. Hathaway "Applications of signal multiplexing in fiber optic-based acoustic and seismic sensors", Proc. SPIE 9834, Laser Technology for Defense and Security XII, 98340X (13 May 2016); https://doi.org/10.1117/12.2223211
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Sensors

Multiplexing

Signal processing

Acoustics

Seismic sensors

Optical fibers

Optical fiber cables

Back to Top