Paper
23 August 2000 Critical dimension control of 0.18-μm logic with dual polysilicon gate
Kung Linliu, Yu-I Wang
Author Affiliations +
Abstract
A dual polysilicon gate structure is required to increase the circuit speed and the packing density, as well as the low-power operation as the design rule of CMOS scales down to sub- 0.25micrometers . In order to get the superior device performance of 0.18micrometers logic device, we need to do the gate implantation prior to polysilicon etch. The critical dimensions (CD) different between NMOS and PMOS during polysilicon gate etching needs to be reduced for matching the design drive current of NMOS and PMOS. In this work, the pressure, the bias power, the total flow of CF4 and Cl2 and the N2 flow are used for the investigation of 0.18micrometers device during the dual gate etch. After optimizing all etch parameters, the CD offset is small between NMOS and PMOS. The vertical profile, the small bias, and CD micro-loading are obtained using in-situ BARC and polysilicon etching. The result of pitting free, stringers free and notching free after dual polysilicon etching is achieved, and the remaining thickness of deep UV photoresist at shoulder is about 800-880A. From this study, both good performance device and the process controllability are obtained with in-situ bottom anti- reflective coating and dual polysilicon gate etching.
© (2000) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Kung Linliu and Yu-I Wang "Critical dimension control of 0.18-μm logic with dual polysilicon gate", Proc. SPIE 4182, Process Control and Diagnostics, (23 August 2000); https://doi.org/10.1117/12.410091
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Etching

Critical dimension metrology

Photoresist materials

Scanning electron microscopy

Oxygen

Nitrogen

Bottom antireflective coatings

Back to Top