Paper
22 August 2002 Parameter optimization of EPON physical layer and the performance analysis for burst mode receiver
Author Affiliations +
Proceedings Volume 4908, Metro and Access Networks II; (2002) https://doi.org/10.1117/12.480718
Event: Asia-Pacific Optical and Wireless Communications 2002, 2002, Shanghai, China
Abstract
EPON (Ethernet Passive Optical Network) is a new technology for access network based on Ethernet protocol. In this paper, a system model is established to simulate the EPON system. The different noise sources that affect the system performance are taken into account, including 1ST, MIPN, RIN, Extinction Ratio, etc. Not only the system performance degradation induced by burst-mode reception but also the requirement and effect of FEC are considered. The optimal system parameters are found to achieve a tradeoff between system performance and cost. At last, a technical scheme technically and economically feasible for China is put forward. More attention is paid to the burst mode operation which leads to the system performance degradation. A theoretical model is adopted to determine the sensitivity penalty caused by burst mode reception.
© (2002) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Haicheng Wang and Rujian Lin "Parameter optimization of EPON physical layer and the performance analysis for burst mode receiver", Proc. SPIE 4908, Metro and Access Networks II, (22 August 2002); https://doi.org/10.1117/12.480718
Lens.org Logo
CITATIONS
Cited by 1 scholarly publication.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Receivers

Forward error correction

Vertical cavity surface emitting lasers

Avalanche photodetectors

Fiber lasers

Modes of laser operation

Signal to noise ratio

Back to Top