Paper
6 October 2003 The selection of Lorenz laser parameters for transmission in the SMF 3rd transmission window
Jerzy K. Gajda, Andrzej Niesterowicz, Grzegorz Zeglinski
Author Affiliations +
Proceedings Volume 5230, Laser Technology VII: Progress in Lasers; (2003) https://doi.org/10.1117/12.531772
Event: 2003 Chapter books, 2003, Bellingham, WA, United States
Abstract
The work presents simulation of transmission line results with the fiber standard ITU-T G.652. The parameters of Lorenz laser decide about electrical signal parameters like eye pattern, jitter, BER, S/N, Q-factor, scattering diagram. For a short line lasers with linewidth larger than 100MHz can be used. In the paper cases for 10 Gbit/s and 40 Gbit/s transmission and the fiber length 30km, 50km, and 70km are calculated. The average open eye patterns were 1*10-5-120*10-5. The Q factor was 10-23dB. In calcuations the bit error rate (BER) was 10-40-10-4. If the bandwidth of Lorenz laser increases from 10 MHz to 500MHz a distance of transmission decrease from 70km to 30km. Very important for transmission distance is a rate bit of transmitter. If a bit rate increase from 10Gbit/s to 40 Gbit/s, the transmission distance for the signal mode fiber G.652 will decrease from 70km to 5km.
© (2003) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Jerzy K. Gajda, Andrzej Niesterowicz, and Grzegorz Zeglinski "The selection of Lorenz laser parameters for transmission in the SMF 3rd transmission window", Proc. SPIE 5230, Laser Technology VII: Progress in Lasers, (6 October 2003); https://doi.org/10.1117/12.531772
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Eye

Single mode fibers

Laser optics

Scattering

Transmitters

Fiber lasers

Laser scattering

Back to Top