Paper
8 June 2005 Percussion drilling of polyimide using VUV and UV solid state lasers
Author Affiliations +
Abstract
Percussion drilling of blind holes and vias in Kapton film was investigated using Q-switched solid state lasers operating at UV (355nm) and VUV (266nm) wavelengths. Holes were analyzed using different methods such as scanning electron microscopy (SEM) and surface profilometry. Ablation rates for the two wavelengths are compared. No abrupt thresholds were found and there was no evidence of an incubation effect within the first few pulses. Introducing pauses during the drilling increased the number of shots required for perforation of the film. The effects of fluence on diameter, depth and taper of the holes are presented. Smaller and neater holes are achieved more accurately with a lower fluence. An observed skin effect brought about by long exposure to low fluence VUV laser light is also discussed.
© (2005) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
C. Mullan, D. Ilie, Sebastian Favre, Gerard M. O'Connor, and Thomas J. Glynn "Percussion drilling of polyimide using VUV and UV solid state lasers", Proc. SPIE 5827, Opto-Ireland 2005: Photonic Engineering, (8 June 2005); https://doi.org/10.1117/12.605151
Lens.org Logo
CITATIONS
Cited by 4 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Laser ablation

Laser drilling

Ultraviolet radiation

Vacuum ultraviolet

Solid state lasers

Diode pumped solid state lasers

Scanning electron microscopy

RELATED CONTENT


Back to Top