Paper
6 April 2006 Experimental test for numerical simulation of SMA characteristics and its simulation
Sanghaun Kim, Hyunho Choi, Manwon Yoon, Maenghyo Cho
Author Affiliations +
Abstract
Shape memory alloy (SMA) can exhibit interesting features such as the diverse material behaviors according to the induced temperature and stress. SMA changes its material properties progressively under cyclic loading conditions and finally reaches stable path(state) after a certain number of stress/temperature loading-unloading cycles, so called 'training' completion. The presence of permanent deformation, due to plastic strains or irreversible martensite variants during the material training, shifts the material characteristic curves of SMA wire. In this study, SMA wires that have been in a stable state through the training are used. Stress-strain curve of SMA wire at different temperature levels are measured. In addition, we observe other important effects such as the effect of mechanical/thermal training, rate effect according to thermal cycle times or strain rates, etc. Until now, the rate effect is not considered significantly in the SMA research and only extremely slow time rate is considered in most SMA experiments. It is common to use rate independent constitutive relations in the modeling and simulation of SMA behaviors. Therefore to make the actuators using an SMA wire which has the fast response or short-time thermal cycle environment, rate dependency should be properly considered. The result of two-way experiment at each (short or long) cycle time in phenomenological aspect shows that stress-strain-temperature relations and hysteresis characteristics depend upon the cycle time. In short-time cycle, strain-temperature curve moves in counterclockwise and the size of hysteresis envelop is large. As the time rate of the thermal cycle increases, the size of the hysteresis envelop is getting smaller and strain-temperature curve moves along the clockwise direction above a certain thermal cycle time. Above that thermal cycle time, hysteresis trajectory is fixed in the stable state. These new effects of SMA are investigated and the effect would be explained qualitatively. The present work presents the experimental test using 1-D SMA wire after training completion by mechanical/thermal cycling. Through these tests, we measure the characteristics of SMA. With the estimated SMA properties and effects, we compare the experimental results with the simulation results based on the SMA constitutive equation including the training and thermal rate effect.
© (2006) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Sanghaun Kim, Hyunho Choi, Manwon Yoon, and Maenghyo Cho "Experimental test for numerical simulation of SMA characteristics and its simulation", Proc. SPIE 6170, Smart Structures and Materials 2006: Active Materials: Behavior and Mechanics, 61700Z (6 April 2006); https://doi.org/10.1117/12.658915
Lens.org Logo
CITATIONS
Cited by 3 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Shape memory alloys

Actuators

Temperature metrology

Thermal effects

Protactinium

Manufacturing

Numerical simulations

Back to Top