Paper
1 November 2007 Practical use of hard mask process to fabricate fine photomasks for 45nm node and beyond
Author Affiliations +
Abstract
New process with hard-mask (HM) blanks was evaluated as one of candidates for photomasks beyond 45nm-node. Through the fabrication of gate-layer photomasks, aptitude of the HM process for practical use was confirmed from the view of controllability on CDs and defects. Although conventional process for attenuated PSM was shown to have critical CD error which belongs to the "patterns" in bright-field masks, experimental data proved effectiveness of the HM process to control CDs after process optimization. With the HM blanks, remarkable reduction of CD error more than 80% of conventional process was confirmed. In this report, peculiar opaque defects are also shown to be a critical issue on the HM process. From results of design of experiment (DOE), combining the proper means to prepare the HM blanks with the optimized HM etching condition, these defects were proved to be controlled within the tolerance for production. Through the investigations, validity of the HM process on practical use for mask fabrication of 45nm-node and beyond is considered as conclusions.
© (2007) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Yasuyuki Kushida, Hitoshi Handa, Hiroshi Maruyama, Yuuki Abe, Yukihiro Fujimura, and Toshifumi Yokoyama "Practical use of hard mask process to fabricate fine photomasks for 45nm node and beyond", Proc. SPIE 6730, Photomask Technology 2007, 673045 (1 November 2007); https://doi.org/10.1117/12.751244
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Etching

Line width roughness

Photomasks

Chromium

Cadmium sulfide

Process control

SRAF

Back to Top