Paper
15 September 2011 Dynamic distortion calibration using a diffracting pupil: high precision astrometry laboratory demonstration for exoplanet detection
Author Affiliations +
Abstract
Detection of earth-size exoplanets using the astrometric signal of the host star requires sub microarcsecond measurement precision. One major challenge in achieving this precision using a medium-size (<2-m) space telescope is the calibration of dynamic distortions. The researchers propose a diffractive pupil technique that uses an array of approximately 50um dots on the primary mirror that generate polychromatic diffraction spikes in the focal plane. The diffraction spikes encode optical distortions in the optical system and may be used to calibrate astrometric measurements. This concept can be used simultaneously with coronagraphy for exhaustive characterization of exoplanets (mass, spectra, orbit). At the University of Arizona, a high precision astrometry laboratory is being developed to demonstrate the capabilities of this diffractive pupil concept. The researchers aim to achieve 10 μas single-axis precision in the laboratory, simulating 0.14 μas precision on a 1.4 m space telescope. This paper describes this laboratory and presents the data and results obtained so far.
© (2011) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Eduardo A. Bendek, S. Mark Ammons, Harish Shankar, and Olivier Guyon "Dynamic distortion calibration using a diffracting pupil: high precision astrometry laboratory demonstration for exoplanet detection", Proc. SPIE 8151, Techniques and Instrumentation for Detection of Exoplanets V, 81510U (15 September 2011); https://doi.org/10.1117/12.893130
Lens.org Logo
CITATIONS
Cited by 3 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Stars

Distortion

Mirrors

Diffraction

Signal to noise ratio

Space telescopes

Device simulation

Back to Top