Paper
27 February 2015 Fabrication of SiC membrane HCG blue reflector using nanoimprint lithography
Author Affiliations +
Proceedings Volume 9372, High Contrast Metastructures IV; 937207 (2015) https://doi.org/10.1117/12.2077391
Event: SPIE OPTO, 2015, San Francisco, California, United States
Abstract
We designed and fabricated a suspended SiC-based membrane high contrast grating (HCG) reflectors. The rigorous coupled-wave analysis (RCWA) was employed to verify the structural parameters including grating periods, grating height, filling factors and air-gap height. From the optimized simulation results, the designed SiC-based membrane HCG has a wide reflection stopband (reflectivity (R) <90%) of 135 nm for the TE polarization, which centered at 480 nm. The suspended SiC-based membrane HCG reflectors were fabricated by nanoimprint lithography and two-step etching technique. The corresponding reflectivity was measured by using a micro-reflectivity spectrometer. The experimental results show a high reflectivity (R<90%), which is in good agreement with simulation results. This achievement should have an impact on numerous III-N based photonic devices operating in the blue wavelength or even ultraviolet region.
© (2015) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Ying-Yu Lai, Akihiro Matsutani, Tien-Chang Lu, Shing-Chung Wang, and Fumio Koyama "Fabrication of SiC membrane HCG blue reflector using nanoimprint lithography", Proc. SPIE 9372, High Contrast Metastructures IV, 937207 (27 February 2015); https://doi.org/10.1117/12.2077391
Lens.org Logo
CITATIONS
Cited by 4 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Silicon carbide

Reflectors

Nanoimprint lithography

Silicon

Reflectivity

Etching

Scanning electron microscopy

Back to Top