Paper
27 April 2016 Study of thermal annealing effect on Bragg gratings photo-inscribed in step-index polymer optical fibers
X. Hu, D. Kinet, P. Mégret, C. Caucheteur
Author Affiliations +
Abstract
In this paper, both non-annealed and annealed trans-4-stilbenemethanol-doped step-index polymer optical fibers were photo-inscribed using a 325 nm HeCd laser with two different beam power densities reaching the fiber core. In the high density regime where 637 mW/mm2 are used, the grating reflectivity is stable over time after the photo-writing process but the reflected spectrum is of limited quality, as the grating physical length is limited to 1.2 mm. To produce longer gratings exhibiting more interesting spectral features, the beam is enlarged to 6 mm, decreasing the power density to 127 mW/mm2. In this second regime, the grating reflectivity is not stable after the inscription process but tends to decay for both kinds of fibers. A fortunate property in this case results from the possibility to fully recover the initial reflectivity using a post-inscription thermal annealing, where the gratings are annealed at 80 °C during 2 days. The observed evolutions for both regimes are attributed to the behavior of the excited intermediate states between the excited singlet and the ground singlet state of trans- and cis-isomers as well as the temperature-dependent glassy polymer matrix.
© (2016) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
X. Hu, D. Kinet, P. Mégret, and C. Caucheteur "Study of thermal annealing effect on Bragg gratings photo-inscribed in step-index polymer optical fibers", Proc. SPIE 9886, Micro-Structured and Specialty Optical Fibres IV, 98860U (27 April 2016); https://doi.org/10.1117/12.2227690
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Fiber Bragg gratings

Polymer optical fibers

Annealing

Reflectivity

Refractive index

Thermal effects

Polymers

Back to Top