Reactive pulsed DC sputtering was used to grow a systematic series of films with resistivity ranging from 1 × 10-3 to 6.8
× 104 Ohm cm and TCR varying from 0 to -4% K-1. Throughout the parameter space studied a transition from
amorphous to nano-crystalline growth was observed. Films in the resistivity range of interest for microbolometers
contained a FCC VOx (0.8 < x < 1.3) phase. Altering the sputtering energetics via substrate biasing resulted in highlycolumnar,
nano-twinned grains of FCC VOx, providing a microstructure reminiscent of ion beam sputtered bolometer
material. Electron diffraction in the TEM confirmed the presence of a secondary, oxygen-rich amorphous phase. Micro-
Raman spectroscopy, which was also found to be sensitive to the secondary amorphous phase, was used to probe the
chemical composition and morphology of VOx thin films. Raman spectra from high resistivity amorphous films show a
broad feature around ~890 cm-1, while spectra from lower resistivity nano-crystalline films exhibit this same amorphous
feature and a second broad feature at ~320 cm-1. The resulting microstructure can be described as a nano-composite
material composed of a low-resistivity crystalline phase embedded in a high-resistivity amorphous matrix. Our results
suggest that both phases are required to achieve a high TCR, low resistivity material.
Uncooled Infrared (IR) focal plane arrays are an enabling technology for both military and commercial high sensitivity
night vision cameras. IR imaging is accomplished using MEMS microbolometers fabricated on read-out integrated
circuits and depends critically on the material used to absorb the incoming IR radiation. Suitable detector materials must
exhibit a large temperature coefficient of resistance (TCR) and low noise characteristics to efficiently detect IR photons
while also maintaining compatibility with standard integrated circuit (IC) processing. The most commonly used material
in uncooled infrared imaging detectors is vanadium oxide deposited by reactive ion beam sputtering. Here we present a
comparison of vanadium oxide thin films grown via commercial reactive ion beam sputtering to films grown using
reactive pulsed DC magnetron sputtering. Films deposited using both methods were optically and structurally
characterized using Raman spectroscopy, transmission electron microscopy, atomic force microscopy and grazing
incidence X-ray diffraction. The measured electrical properties of the films were found to be very sensitive to the
deposition conditions used. The ion beam sputtered films contained twinned FCC VOx nanocrystals with sub-nanometer
twin spacing, in the form of large 10-20 nm wide columnar/conical grains. In contrast, the un-biased magnetron
sputtered films consisted of equiax grains of FCC VOx (5-10 nm) encapsulated in an amorphous matrix. However,
applying an RF bias to the sample substrate during the magnetron sputtering process, resulted in films that are similar in
structure to ion beam deposited VOx. These differences in microstructure and composition were then correlated to the
measured resistivities and TCRs of the films.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.