AlGaN-based UVC laser diodes operating at wavelengths are expected to be a low-cost, environmentally friendly, and highly efficient laser light source for a variety of applications. In this study, we further reduced the threshold gain by improving the optical confinement and improved the threshold current density while lowering drive voltage. A threshold current density of 2.8 kA/cm2 was achieved in pulsed current operation, and an operating voltage as low as 9.6 V was also achieved. Furthermore, the packaged device successfully emits CW light at a wavelength of 274.8 nm with a DC current operation of over 110 mA at 5°C.
Deep-ultraviolet laser diodes have achieved pulsed lasing at room temperature by improving the crystal quality and establishing a hole injection method using polarization doping techniques. In the initial demonstration, the threshold current density was very high at 25kA/cm2, which is a major barrier to continuous-wave lasing. The reason for this high threshold current density was found to be process-induced non-uniformity of emission. By suppressing this non-uniformity through LD device design, we were able to significantly reduce the threshold current density to about 12 kA/cm2.
UV-C laser diodes (LDs) have not been realized for many years owing to the problems of crystal quality and p-type conductivity control. In our group, AlGaN-based LD structures with low dislocation density were fabricated using AlN single-crystal substrates, and a p-type cladding layer with sufficient hole concentration was realized without impurities doped by distributed polarization doping (DPD). As a result, we have demonstrated pulsed current injection UV-C LDs at room temperature. We have also developed an on-wafer process technology to solve the problems of LDs manufactured by the conventional cleavage method. The key points of this method are the flatness of mirror facets, their angle to the cavity, and the coating of distributed Bragg reflector (DBR) on the mirror facets formed perpendicular to the wafer. The method is a combination of dry etching and TMAH wet etching to selectively expose the m-plane, and the DBR fabrication by atomic layer deposition (ALD) which provides good coverage. The LDs fabricated by the on-wafer method were observed to lase in the UV-C region when a pulsed current was injected similarly to the LDs fabricated by the cleavage method. These results indicate the potential of not only the realization of UV-C LDs but also for the fabrication of devices using high-Al-composition AlGaN with p-type conductivity and optical integrated circuits.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.