Paper
5 June 2024 Design and investigation of an airbag-free buffer throttle device
Naijin Qiang, Yuanqiang Li, Heng Li
Author Affiliations +
Proceedings Volume 13163, Fourth International Conference on Mechanical, Electronics, and Electrical and Automation Control (METMS 2024); 131630M (2024) https://doi.org/10.1117/12.3030222
Event: International Conference on Mechanical, Electronics, and Electrical and Automation Control (METMS 2024), 2024, Xi'an, China
Abstract
This paper introduces the design of a airbag-free buffer throttle device aimed at mitigating the fatigue effects associated with airbag cushions while ensuring consistent throttling effects. The structural model of the buffer throttle device was crafted using SOLIDWORKS software and subsequently simulated and validated through FLUENT fluid simulation software. The study delves into pressure variations within the buffer throttle device under various orifice sizes, examining the impact of different structures on pressure pulsation. At a design inlet flow rate of 500 mL/min, the air pressure inside the device registers at approximately 4 KPa. Both simulation outcomes and real-world observations affirm that a throttle orifice with a side length of 0.5 mm and three layers of orifices best aligns with the design requirements. The front buffer section incorporates three buffer structures, namely S-type, cavity, and a single orifice plate. Simulation results highlight that the single orifice plate structure demonstrates the most effective pressure pulsation suppression, with this effect intensifying as the side length decreases.
(2024) Published by SPIE. Downloading of the abstract is permitted for personal use only.
Naijin Qiang, Yuanqiang Li, and Heng Li "Design and investigation of an airbag-free buffer throttle device", Proc. SPIE 13163, Fourth International Conference on Mechanical, Electronics, and Electrical and Automation Control (METMS 2024), 131630M (5 June 2024); https://doi.org/10.1117/12.3030222
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Design

3D modeling

3D printing

Material fatigue

Solids

Attenuation

Structural design

Back to Top