Tunable silicon microring filters are used to demonstrate CMOS-compatible on-chip wavelength control of Er+ doped
fiber-lasers. The filter uses a 10 μm-diameter microring resonator based on single-mode silicon-on-insulator (SOI) strip
waveguides operating around the telecom range of 1.55 μm. A piece of Er+ doped fiber (EDF) serves as the gain media
which is pumped by a 980 nm laser diode. An on-chip Ni-Cr micro-heater consuming up to 38 mW is capable of tuning
the Si microring filter by 2.3 nm with a lasing linewidths narrower than 0.02 nm. This approach enables arbitrary
multiple wavelength generation on a silicon chip. Possible applications include on-chip and chip-to-chip densewavelength
division multiplexed communications, telecommunications and optical sensor interrogation.
Microring resonators (MRs) are important photonic devices for large-port-count photonic circuits owing to their micrometer-scale device sizes. We describe the implementation of a 4×4 wavelength-reconfigurable photonic switch consisting of eight tunable MRs fabricated on a less expensive material platform: silicon on insulator. Wavelength reconfiguration is achieved through independent thermo-optic tuning of MRs with localized Nichrome microheaters fabricated on the same silicon-on-insulator substrate. A free spectral range of 18 nm and a 3-dB linewidth of 0.1 nm were observed for the fabricated MRs with a diameter of approximately 10 µm. The switch device shows negligible channel crosstalk (<0.01 nm) and moderate switching response time (<1 ms). The switch can potentially be scaled up to benefit the development of large-scale integrated photonics.
Micro-ring resonators have been traditionally fabricated using expensive III-V materials such as InP or GaAs. Device
tuning is typically to utilize the electro-optic effect of the III-V materials that usually leads to complex device layer
structures. As another tuning approach, thermo-optic tuning of micro-ring resonators is commonly achieved by heating
up the whole chip. In general, it is more challenging to achieve highly localized heating on a common chip for
independent tuning of multiple micro-ring resonators residing on the same substrate. To address these issues, we
describe the development of wavelength reconfigurable photonic switching using thermally tuned micro-ring resonators
fabricated on a low-cost silicon-on-insulator substrate. Independent tuning of multiple micro-ring resonators, spaced at
250 µm, is realized with highly localized micro heaters (50×50 μm2 per heater area) fabricated on the same silicon
substrate. Owing to the large thermo-optic effect of silicon (Δn/ΔT=1.8×10-4 K-1), 8 mA heating current is sufficient to
tune a micro-ring resonator with a 3-dB spectral line width of 0.1 nm by 2.5 nm while creating a minor peak shift of less
than 0.04 nm for an adjacent resonator. The switching response time is about 1 ms. A 1×4 wavelength reconfigurable
photonic switch device has been demonstrated. With a resonator diameter of approximately 10 μm (greater than 18 nm
in free spectral range of each micro-ring resonator), larger port-count switch matrix with wavelength reconfiguration on
a small device foot print is feasible for the development of large-scale integrated photonics.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.