GRBAlpha is a 1U CubeSat launched in March 2021 to a sun-synchronous LEO at an altitude of 550 km to perform an in-orbit demonstration of a novel gamma-ray burst detector developed for CubeSats. VZLUSAT-2 followed ten months later in a similar orbit carrying as a secondary payload a pair of identical detectors as used on the first mission. These instruments detecting gamma-rays in the range of 30-900 keV consist of a 56 cm2 5 mm thin CsI(Tl) scintillator read-out by a row of multi-pixel photon counters (MPPC or SiPM). The scientific motivation is to detect gamma-ray bursts and other HE transient events and serve as a pathfinder for a larger constellation of nanosatellites that could localize these events via triangulation.
At the beginning of July 2024, GRBAlpha detected 140 such transients, while VZLUSAT-2 had 83 positive detections, confirmed by larger GRB missions. Almost a hundred of them are identified as gamma-ray bursts, including extremely bright GRB 221009A and GRB 230307A, detected by both satellites. We were able to characterize the degradation of SiPMs in polar orbit and optimize the duty cycle of the detector system also by using SatNOGS radio network for downlink.
We present the detector performance and early science results from GRBAlpha, a 1U CubeSat mission, which is a technological pathfinder to a future constellation of nanosatellites monitoring gamma-ray bursts (GRBs). GRBAlpha was launched in March 2021 and operates on a 550 km altitude sun-synchronous orbit. The gamma-ray burst detector onboard GRBAlpha consists of a 75×75×5 mm CsI(Tl) scintillator, read out by a dual-channel multi-pixel photon counter (MPPC) setup. It is sensitive in the ∼30−900 keV range. The main goal of GRBAlpha is the in-orbit demonstration of the detector concept, verification of the detector’s lifetime, and measurement of the background level on low-Earth orbit, including regions inside the outer Van Allen radiation belt and in the South Atlantic anomaly. GRBAlpha has already detected five, both long and short, GRBs and two bursts were detected within a time-span of only 8 hours, proving that nanosatellites can be used for routine detection of gamma-ray transients. For one GRB, we were able to obtain a high resolution spectrum and compare it with measurements from the Swift satellite. We find that, due to the variable background, the time fraction of about 67% of the low-Earth polar orbit is suitable for gamma-ray burst detection. One year after launch, the detector
In recent years, the number of CubeSats (U-class spacecrafts) launched into space has increased exponentially marking the dawn of the nanosatellite technology. In general, these satellites have a much smaller mass budget compared to conventional scientific satellites, which limits shielding of scientific instruments against direct and indirect radiation in space. We present a simulation framework to quantify the signal in large field-of-view gamma-ray scintillation detectors of satellites induced by x-ray/gamma-ray transients, by taking into account the response of the detector. Furthermore, we quantify the signal induced by x-ray and particle background sources at a Low-Earth Orbit outside South Atlantic Anomaly and polar regions. Finally, we calculate the signal-to-noise ratio (SNR) taking into account different energy threshold levels. Our simulation can be used to optimize material composition and predict detectability of various astrophysical sources by CubeSats. We apply the developed simulation to a satellite belonging to a planned CAMELOT CubeSat constellation. This project mainly aims to detect short and long gamma-ray bursts (GRBs) and as a secondary science objective, to detect soft gamma-ray repeaters (SGRs) and terrestrial gamma-ray flashes (TGFs). The simulation includes a detailed computer-aided design model of the satellite to take into account the interaction of particles with the material of the satellite as accurately as possible. Results of our simulations predict that CubeSats can complement the large space observatories in high-energy astrophysics for observations of GRBs, SGRs, and TGFs. For the detectors planned to be on board the CAMELOT CubeSats, the simulations show that detections with SNR of at least 9 for median GRB and SGR fluxes are achievable.
GRBAlpha is a 1U CubeSat mission with an expected launch date in the first half of 2021. It carries a 75 × 75 × 5 mm CsI(Tl) scintillator, read out by a dual-channel multi-pixel photon counter (MPPC) setup, to detect gamma-ray bursts (GRBs). The GRB detector is an in-orbit demonstration for the detector system on the Cubesats Applied for MEasuring and LOcalising Transients (CAMELOT) mission. While GRBAlpha provides 1/8th of the expected effective area of CAMELOT, the comparison of the observed light curves with other existing GRB monitoring satellites will allow us to validate the core idea of CAMELOT, i.e. the feasibility of timing-based localization
We propose a fleet of nanosatellites to perform an all-sky monitoring and timing based localisation of gamma-ray transients. The fleet of at least nine 3U cubesats shall be equipped with large and thin CsI(Tl) scintillator based soft gamma-ray detectors read out by multi-pixel photon counters. For bright short gamma-ray bursts (GRBs), by cross-correlating their light curves, the fleet shall be able to determine the time difference of the arriving GRB signal between the satellites and thus determine the source position with an accuracy of ∼ 100 . This requirement demands precise time synchronization and accurate time stamping of the detected gamma-ray photons, which will be achieved by using on-board GPS receivers. Rapid follow up observations at other wavelengths require the capability for fast, nearly simultaneous downlink of data using a global inter-satellite communication network. In terms of all-sky coverage, the proposed fleet will outperform all GRB monitoring missions.
A fleet of nanosatellites using precise timing synchronization provided by the Global Positioning System is a new concept for monitoring the gamma-ray sky that can achieve both all-sky coverage and good localization accuracy. We are proposing this new concept for the mission CubeSats Applied for MEasuring and LOcalising Transients (CAMELOT). The differences in photon arrival times at each satellite are to be used for source localization. Detectors with good photon statistics and the development of a localization algorithm capable of handling a large number of satellites are both essential for this mission. Large, thin CsI scintillator plates are the current candidates for the detectors because of their high light yields. It is challenging to maximize the light-collection efficiency and to understand the position dependence of such thin plates. We have found a multi-channel readout that uses the coincidence technique to be very effective in increasing the light output while keeping a similar noise level to that of a single channel readout. Based on such a detector design, we have developed a localization algorithm for this mission and have found that we can achieve a localization accuracy better than 20 arc minutes and a rate of about 10 short gamma-ray bursts per year.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.